***************************************
                   *                                     *
                   *         EZCFG.EXE  V2.04            *
                   *                                     *
                   ***************************************


PnP EthernetCard Configuration and Diagnostics file
----------------------------------------------------

To configure your PnP EthernetCard, execute the configuration file,EZCFG.
A screen menu will guide you to configure the PnP EthernetCard to fit your
computer system's environment.

The following is the configuration parameters.

   Operating Mode :    NE2000 , PnP

   I/O Address :       200h,220h,240h,260h,280h,2A0h,2C0h,2E0h,300h,320h,
                       340h,360h,380h,3A0h,3C0h,3E0h

   IRQ Line    :       9(2),3,4,5,10,11,12,15

   BOOT ROM Address :  C000H,32K C800H,32K D000H,32K D800H,32K
                       C000H,16K C400H,16K C800H,16K CC00H,16K D000H,16K
                       D400H,16K D800H,16K DC00H,16K

   UTP Duplex Type :   Half-Duplex , Full-Duplex

   Data Width  :       8 bits or 16 bits; auto sensing by hardware




Before you install the drivers and connect the PnP EthernetCard to the network,
make sure to run the diagnostics to assure the proper function of the PnP
EthernetCard. The diagnostics includes two groups of test :

   1. Card initialization and loopback test

      This test performs the function of verifying the components, connectors,
      and circuitry.

   2. Network test

      This test performs the data transmission and reception of the adapter.
      A screen menu provides you with the instructions to conduct this test.

------------------------------------[END]---------------------------------------