Driver Installation Guide for Windows NT 3.5
	  ==================================================

Introduction
============
    This document describes the procedure to install Windows NT 3.5
    driver for PN-16 Series Ethernet Adapter.


Installation Procedures
=======================

    1. If Windows NT operating system is being installed, select other
       manufacturers from the network adapter card options and follow
       steps 3-8.

    2. If Windows NT operating system is already installed, logon as
       Administrator and select Netwrok icon from the control panel.

    3. In the Network Setting dialog box, choose "Add Adapter" button.
       The Add Network Adapter dialog box appears.

    4. In the Add Network Adapter dialog box, pull the adapter card list
       menu and select "<Other>Requires disk from manufacturer" from the
       list, and then press <Enter> button. .

    5. Insert the driver diskette in Drive A/B.

    6. In the next windows, specify the correct drive and path (A:\WINNT35
       or B:\WINNT35) when asked to give the source for the driver, and
       then choose the "OK" button.

    7. Then, select the "PN-16 Series Ethernet Adapter" from the dialog
       box to install PN-16 Series Adapter driver.

    8. Finally close the Setup dialog box and exit from the Add Network
       adapter dialog box to complete the installation. Follow any
       instructions appearing on the screen.

    9. Shutdown and reboot the system.