Driver Installation Guide for Windows For Workgroups 3.11 =============================================================== Introduction ============ This document describes the procedure to install Microsoft Windows for Workgroups 3.11 driver for PN-16 Series Ethernet Adapter. Installation Procedures ======================= 1. Turn your computer off, then Install the PN-16 Series Ethernet Adapter to your computer. 2. After the adapter installation, turn your computer on. 3. Start your Windows for Workgroups 3.11. 4. After Windows Start OK, Select "Network" icon and then Select "Network Setup" icon. 5. Click on the "Drivers..." button. 6. If you are replacing a previous LAN adapter select the Remove button to delete that adapter 7. Click on the "Add Adapter" button. 8. Select "Unlisted or Updated Network Adapter" item bar on the Adapter list. 9. Insert the driver diskette into drive A: or B: and enter A:\WFW311 or B:\WFW311 10. "PN-16 Series Ethernet Adapter" appears in the list and select it, then Select "OK" bar. 11. "PN-16 Series Adapter [NDIS3/NDIS2]" bar appears. It indicates the NDIS driver has been copied into your Windows system. 12. Select "Close" bar and then Select "OK" bar. 13. Windows prompts you to insert several WFW system diskettes. 14. When message "Windows Setup has modified your SYSTEM.INI and PROTOCOL.INI... ....." appears, select "OK" bar. 15. Select "Restart Computer" bar. 16. Now, the Windows for Workgroup 3.11 is ready for your Ethernet Adapter.