Driver installation Guide for Novell NetWare v3.1x server
    ===============================================================

Introduction
============
    This document describes the procedure to install Netware 3.1x server
    driver for PN-16 Series Ethernet Adapter.


Installation Procedures
=======================

    1. Copy PN16.LAN from \netware\3.1x directory of the PN-16 Series
       driver diskette to the hard disk directory where NetWare 3.1x
       system files are locatted.

    2. Boot NetWare file server by executing "SERVER" as you usually do.

    3. When the NetWare 386 prompt appears (indicated by a colon),
       to load the driver manually, simply at the system console screen
       type the following command:

       : Load PN16 INT=x PORT=xxx Frame=Ethernet_xxxx

	or, you can directly load file from PN-16 driver diskette :

       : Load A:\NETWARE\3.1X\PN16 INT=x PORT=xxx Frame=Ethernet_xxxx

       Note : INT and PORT depend on your hardware setting.
	      Frame type depend on your network.

    4. Bind IPX to the adapter driver. At the NetWare server prompt, type:

       : Bind IPX to PN16 Net=xxx

       Note:  Net value depend on your network configuration.

    5. Add the load and bind statements you require to the server's
       AUTOEXEC.NCF file so that the LAN driver will load automatically
       each time the server starts up.