**********************************************************************
 *   NE2000 Compatible Ethernet Cards Setup Program	     V201R00  *
 **********************************************************************
						       Date: 10/12/1994


   A. OVERVIEW
   ===========
   The SETUP.EXE Program is used to configure and verify the correct
   configuration and  operation  of an	NE2000	Compatible  Ethernet
   cards before installing the network software.



   B. BEFORE STARTING THE PROGRAM
   ==============================
   1. Be sure you know the configuration of any adapters.

   2. After turning off the PC's power, insert the adapter into the PC.

       ** Ethernet adapters must be on a properly terminated cable
	  (use a BNC " T " connector with two 50 Ohm terminators or
	   an AUI loopback connector).

   3. Boot the PC to a DOS prompt.

       ** Memory resident (TSR) programs and device drivers should
	  not be loaded while the Diagnostic Program is active, so
	  you may need to temporarily rename your CONFIG.SYS and
	  AUTOEXEC.BAT files.  The Diagnostic Program is always run
	  without loading any network software.



   C. STARTING THE PROGRAM
   =======================

      To change to the SETUP subdirectory. In the DOS prompt, type SETUP
      to run setup program, like as below:

      A:>SETUP



   D. SUPPORT
   ==========
   If you have any additional questions regarding your Diagnostic
   Program, contact your dealer or distributor technical support
   department.

 ======================================================================