Configuring many adapters with the same settings
                                                                    v1.00

To use the identical configuration on multiple adapters, save the
configuration of one adapter and load the saved configuration file onto
another adapter.

When you do this, you're only saving or loading the hardware
configuration. To complete the installation, you must install the network
drivers on each computer.


To save the configuration
=========================

1. Insert the Configuration disk into a drive, and switch to that drive.

2. Type  EX10SET /SAVE=filename

   For example,  EX10SET /SAVE=A:\EX10CONF.CFG

   Or you can type EX10SET and select SAVE/LOAD CONFIGURATION TO FILE,
   then SAVE CONFIGURATION TO FILE. EX10Set asks you to specify where to
   save the file.

   Note: If you have a Plug and Play BIOS, the SAVE/LOAD option in
   EX10Set will be grayed out. You must use the command line option in
   these cases.


To load a saved configuration onto an adapter
=============================================

1. Put the adapter in the computer according the instructions in the
   Installation Guide.

2. Copy the configuration file you want to use onto the computer or onto
   a floppy disk.

3. Insert the Configuration disk into a drive, switch to that drive, and
   type
   
   EX10SET /LOAD=filename

   For example,
   
   EX10SET /LOAD=A:\EX10CONF.CFG

   Or you can type EX10SET and select SAVE/LOAD CONFIGURATION FROM FILE,
   then LOAD CONFIGURATION FROM FILE. EX10Set asks you to specify the
   location of the configuration file you want to use.

Hints and Tips
==============

1. If you receive a message that EX10Set can't load the configuration
   onto the adapter you have, you may be trying to load a configuration
   that was saved for a different type of EtherExpress 10 ISA adapter.

   To verify your configuration file matches the adapter you're trying to
   configure, make sure the adapter has the same number of network
   connectors.