ISA adapters in EISA slots
                                                                    v1.00


Installing an EtherExpress(TM) 10 ISA adapter in an EISA slot
=================================================================

You can install the EtherExpress(TM) 10 ISA adapter in an EISA slot.
Installation requires three steps:

1. Put the adapter in the computer.

   Follow the procedure in the Installation Guide for installing the
   adapter into a slot in the computer.

2. Set the computer's EISA configuration.
   
   A  Restart the computer.
   
   B  Run the most recent version of the EISA Configuration Utility (ECU)
      for this computer.
   
   C  From the Main menu, select the command for configuring the
      computer.
   
   D  Choose the menu item that allows you to add an adapter to your
      computer, then select the slot where the adapter is located.
   
   E  Select the command that allows the ECU to read the adapter's EISA
      configuration files from the Intel diskette.
   
   F  When prompted, insert the Intel Configuration and Drivers disk,
      then select the appropriate file from the list of available adapter
      configuration files. For the EtherExpress 10 ISA adapter, choose
      !int1100.cfg.
   
   G  Write down the settings you want to assign to the EtherExpress 10
      ISA adapter and exit the program. (You must choose settings that
      aren't used by any other device in the computer.)

3. Configure the adapter with EX10Set.
   
   A  Insert the Intel configuration disk into a drive, switch to that
      drive, and type EX10SET.
   
   B  From the Main menu, select Change Adapter Configuration.
   
   C  Select the configuration settings you chose in the EISA
      configuration program.
   
   D  Continue with the setup procedure by testing the adapter and
      installing the driver as shown in the Installation Guide.