*****************************************************************************
*                                                                           *
*                       ISA PnP Ethernet Adapter                            *
*                                                                           *
*                      NDIS Driver for Windows NT v3.51                     *
*                                                                           *
*                         V. 2.5,   Nov. 1996                               *
*                                                                           *
*****************************************************************************

Introduction:
=============

  This document shows you how to setup the driver and how to use the enhanced
  functions by setting the custom keywords.


Contents of the Subdirectory:
=============================

    PNPWNT.SYS          The NDIS3 driver for Windows NT.
    PNPWNT.HLP          The help file.
    OEMSETUP.INF        The setup information file.
    WINNT351.TXT        This file.


Installation:
=============

   Before  starting with the installation process, make sure that the adapter
   is properly installed and configured.

    1. Open "Control Panel" -> "Networks",and choose the "Add Adapter" button.
       The Add Noetwork Adapter  dialog box appears.  Select "<other> Requires
       disk from manufacturer" in the list of Network Adapters, and then press
       <Enter>.

    2. Insert the driver diskette into your floppy drive, and specify the path
       of the driver in the diskette(i.e. A:\WINNT351) if necessary.

    3. Select "ISA Plug & Play Ethernet Adapter", and start to copy the driver
       files to your system.

    4. After all the driver files  have  been  copy to your system, a property
       dialog box appear in the screen. You  can enable the specail properties
       if you want to.Please refer to the next section to setup the properties.

    5. When the driver installation is completed, restart your PC.


Configuration Parameters:
=========================
    Configuration:
    --------------
      1) Open "Control Panel" -> "Networks", Press "Configure.." in the Netork
         Settings dialog  box, and a property dialog box appear in the screen.

      2) You will see the following properties:
         EarlyReceive,EarlyTransmit,FullDuplex, and PNPID. Turn the properties
         on if you want to enable the functions.



    Custom Keywords:
    ----------------
        PNPID = hhhhhhhhhhhh        This keyword is the Ethernet Address of
                                    the adapter you want to drive. If there
                                    are more than one ethernet  adapters in
                                    your  system ,  you  have  to  use this
                                    keyword to let driver locate  the right
                                    adapter. However, you don't have to use
                                    this  keyword  or  let the value  to be
                                    zero (i.e. PNPID = 0) if  there is only
                                    one adapter in your system.

        EARLYTRANSMIT               This  keyword  is  used to enable turbo
                                    transmission mode for accelerating data
                                    transmission.

        EARLYRECEIVE                This keyword  is  used  to enable turbo
                                    receiption mode  for  accelerating data
                                    receiption.

        FULLDUPLEX                  This  keyword is  used  to  enable full
                                    duplex mode.