==================================================================
NOTES ON
Installing D-Link DE-220 Family Ethernet Adapter
For D-Link's TCP/IP Users
==================================================================
    (c) 1997 Copyright D-Link Corporation  ALL RIGHTS RESERVED

This document contains installation notes, which is not included in the
DE-220 Family Ethernet Adapter USER'S GUIDE or onscreen instructions,
for D-Link's TCP/IP users regarding DE-220 Family Ethernet Adapter
installation.

( Please note the "D-Link's TCP/IP" is the TCP/IP program
                       which has been modified by D-Link.)

This document contains information on the following topics:

1.0 Introduction
2.0 Installing Packet driver
___________________________________________________________________

1.0 Introduction
----------------

D-Link's TCP/IP users please also refer to the following:

    -------------------------------------------------------------------
     File                  Description/Installation notes
    -------------------------------------------------------------------
     \README.TXT           For all users
     \PKTDRV\README.TXT    For all Packet driver users

2.0   Installing Packet Driver
------------------------------

There are two methods to run the D-Link's TCP/IP program.

    METHOD 1:
    ÄÄÄÄÄÄÄÄÄ
    In your CONFIG.SYS file, include the DEVICE command.

        Format:
        DEVICE = DE22XPD.SYS [/d] [/w] <packet_int_no>

        <packet_int_no> is the software interrupt vector number used by
                        the packet driver program. This can be from 96 to
                        128.

        /d              Delay Initial - The driver program will not
                        initialize the network interface card until the
                        packet driver program is accessed by its upper
                        layer program.

        /w              The -w parameter is for use only in the Windows
                        environment.

        See \PKTDRV\README.TXT for addition parameters

    METHOD 2:
    ÄÄÄÄÄÄÄÄÄ
    1. In your AUTOEXEC.BAT file, include the following command lines:
        Format:
        set HOSTS=<PATH>

        <PATH> is the directory where the D-Link TCP/IP programs reside.

    2. Issue DE22XPD command at the MS-DOS command prompt:

        Format:
        DE22XPD [/d] [/w] <packet_int_no>

    3. Run TCPSTART.EXE, at the DOS command prompt, to start TCP/IP.