Quantum ProDrive LPS80AT


The following values are used to set the PC/AT CMOS Table.

Cylinder	611
Heads		16
Sectors		17
Write Precomp	None or 65535*
Landing Zone	611

*= The Quantum ProDrive does not require Write Pre compensation, your CMOS setting should be set to reflect that this feature is not enabled. A value of 65535 is a number that many BIOS manufactures use to disable this feature if the value 'none' is not present.

Jumper Settings


The Prodrive LPS has three drive mode jumper options; DS, SP and DM. To configure the drive as:

The SP jumper is only used when the second drive in a two drive configuration does not support DASP. DASP (Drive active / drive 1 present) is a CAM (Common Access Method) defined signal that indicates the presence of a second drive, DASP is used during power on initialization and after a reset. Prior to this definition, products were introduced which did not utilize this method to detect the presence of a second drive. The SP jumper is only used on the MASTER drive, with the DS jumper, when the second drive does not support DASP.


Copyright 1995 Quantum Corporation
500 McCarthy Blvd, Milpitas, CA 95035
408-894-4000
We are always interested in any suggestions you might have regarding this service.
Note: Some files are available in PDF Format.