=============================================================================== Maxtor 7060S/7120S Jumper Designation And Parameters Jumper Block Pin Location Function J601 1-2 Terminator Power J601 3-4 Diagnostic Mode (Factory Use Only) J601 5-6 Disable Parity J601 7-8 Reserved J602 1-2 Power-up Option J602 3-4 Not Used J602 5-6 Target ID Address (Most Significant Bit - MSB) J602 7-8 Target ID Address J602 9-10 Target ID Address (Least Significant Bit - LSB) //\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\//\/\/\/\/\/\/\/\/\\ # # # # -+- # # # # \-\ J602 J601 /-/ # /--\ /--\ # # #..#9-10 #..#7-8 # /-/ #**#7-8 #..#5-6 \-\ \\ #**#5-6 #..#3-4 // # #..#3-4 #**#1-2 # // #**#1-2 \--/ \\ # \--/ # # # # # # # # -+- -+- # # # RP602 RP601 # # # /-----------.\ /-----------.\ # # \------------/ \------------/ # # # +-+---+---+---+-+-+++++++++++++++++++++++++++++++++++++++++-# # J2 # J1 # \---------------+-------------------------------------------/ pin1 pin1 Shown with Default Jumper settings BASIC INSTALLATION STEPS - Drive is shipped with an ID of 6 to provide spare jumpers. Choose address jumpers according to specific installation requirments. - The last physical device on the SCSI bus must be terminated. Any other SCSI device connected between the host and the device at the end of the bus must NOT be terminated. - Install a 50-pin ribbon connector. The striped edge of the 50-pin ribbon cable represents pin 1 and must be oriented towards pin 1 at the drive connector and the host connector. - Install the DC power connector. - Secure the drive in a bay with 6-32 x 1/4" screws. - Set the drive type in the AT BIOS setup to "not installed". Note: This intelligent drive will identify itself to the system and SCSI host adaptor. - The drive is now ready for partitioning and high-level formatting with any operating system. For example: Partition the drive using the FDISK program from MS-DOS version 3.3 or higher. High-level format the drive using the FORMAT command from MS-DOS version 3.3 or higher.