Fujitsu M2511A:Switch Settings


PCA Layout    All configurations marked "*" are default settings

There are two different layouts of PCA for this drive therefore serial numbers must be checked before adjustments are made. The only functional differences are in terminal CNH1 and CNH2. See the board layout diagram for the physical differences. The functions of switch bank SW1 and SW2 remain the same. To maintain backward compatibility, an external connector designed for the early version PCA for CNH2 will fit directly on to the pins 2, 4, 6, and 8 of the later version.


Switch SW1

Key 1 OFF(*) Reserved

Select SCSI ID Keys 2 3 4 SCSI ID OFF* OFF* OFF* 0 OFF OFF ON 1 OFF ON OFF 2 OFF ON ON 3 ON OFF OFF 4 ON OFF ON 5 ON ON OFF 6 ON ON ON 7

Switch SW2


SCSI bus parity Key 1 ON(*) Enabled OFF Disabled Synchronous Data Transfer Request Mode (SDTR) Key 2 OFF(*) Disabled from TARG ON Enabled from TARG Device mode Key 3 OFF(*) Direct access device (INQ = 00) ON Optical memory device (INQ = 07) Automatic spindle stop mode Key 4 OFF Disabled ON(*) Enabled Command compatibility Key 5 OFF(*) Sony MO compatible ON ANSI compatible Key 6 OFF(*) RESERVED Macintosh Mode Key 7 OFF(*) Mac mode off ON Mac mode on Send/Receive Diagnostic Command Key 8 OFF(*) Rejected ON Accepted

Terminal CNH 1 (For drives with serial above 30,000)


SCSI Terminating Power 1-2 3-4 Function SHORT(*) SHORT(*) Power is supplied from the drive to both the terminating resistor pack and the TERMPWR pin on the SCSI bus. (Pin 26) OPEN SHORT The TERMPWR pin is not used. Power is supplied to the drive terminating resistor only from the drive. SHORT OPEN Power is not supplied to the terminating resistor from the drive, only from the TERMPWR pin.

Terminal CNH1 (For drives with serial below 30,000)


SCSI Terminating Power 1 - 2 SHORT(*) The TERMPWR pin is not used. Power is supplied to the drive terminating resistor only from the drive. 2 - 3 SHORT Power is not supplied to the terminating resistor from the drive, only from the TERMPWR pin. (Pin 26)

Terminal CNH1 (For drives with serial above 30,000)


Pin Signal 1 CTRGIN (Cartridge in) 2 -ID2 (bit value 4) 3 +5VS 4 -ID1 (bit value 2) 5 ELED (LED control) 6 -ID0 (bit value 1) 7 EJSW (Eject switch) 8 Ground 9 DEVMD (Device mode) 10 No connection 11 MACMD (MAC Mode) 12 No connection

Terminal CNH2 (For drives with serial below 30,000)


Pin Signal 1 -ID2 (bit value 4) 2 -ID1 (bit value 2) 3 -ID0 (bit value 1) 4 Ground


to the table of contents!!