Fujitsu M2704S/M2705S/M2706S:Switch Settings
PCA Layout All configurations marked * are default settings.
Set SCSI ID
JMP7 JMP6 JMP5 ID OPEN OPEN OPEN 0 OPEN OPEN SHORT 1 OPEN SHORT OPEN 2 OPEN SHORT SHORT 3 SHORT OPEN OPEN 4 SHORT OPEN SHORT 5 SHORT SHORT OPEN 6 SHORT* SHORT* SHORT* 7
The drive is shipped from the factory with the SCSI ID set to 7. This provides the drive with enough shorting straps for any ID. It must be remembered though that the host adapter normally takes ID 7 with all peripheral devices using IDs 0 through to 6.
JMP4 SHORT* Spin up at power on OPEN Spin via START/STOP UNIT command JMP3 SHORT* SCSI parity enabled OPEN SCSI parity disabled JMP2 SHORT* UNIT ATTENTION enabled OPEN UNIT ATTENTION disabled JMP1 SHORT* SCSI level:Common Command Set OPEN SCSI level:SCSI-2
to the table of contents!!