Fujitsu M2611S/M2611SA/M2611SB:Switch Settings

PCA Layout  All configurations marked "*" are default settings

Setting Plugs CNH1

        Pins    Status     Function
        1-2     OPEN(*)    SCSI ID bit value 1
        3-4     OPEN(*)    SCSI ID bit value 2
        5-6     OPEN(*)    SCSI ID bit value 4
        7-8     OPEN       Spin up via command
                SHORT(*)   Spin up on power up
 (notes)
        1-6;    Always ensure that each device on the SCSI bus has been
                assigned a unique ID.
        7-8;    Remove this jumper only if the host adapter supports
                START/STOP UNIT command.

Setting Plugs CNH2

        Pins    Status     Function
        1-2     OPEN       Supply BUS line terminator power from IDD disabled
                SHORT(*)   Supply BUS line terminator power from IDD enabled
        3-4     OPEN       Supply BUS line terminator power to/from
                           TERMPWR disabled
                SHORT(*)   Supply BUS line terminator power to/from
                           TERMPWR enabled
        5-6     OPEN(*)    Reserved (Do not change)

Dip switch setting

Write protect
       Key1      ON 	Write protect
                 OFF(*)	Non write protect
Motor Control
       Key2      ON(*)  Self-starting
                 OFF    Waiting MOTOR START command
Self-diagnostic mode
       Key3      ON     Normal mode
                 OFF(*) Test mode

to the table of contents!!