C/D
The C/D jumper is used to determine whether the drive is master (drive C) or slave (drive D). The drive is configured as a master (drive C) when jumped and as a slave (drive D) when not jumpered.
DSP & SS This pair of jumpers determines the signals on pin 39 of the interface connector.
| Jumper DSP SS | Action | |
|---|---|---|
| X | -spindle synchronizaation signal disabled on pin 39 -activity LED signal available on pin 39 -Must be in place for CAM/ATA drives. |
|
| X | -spindle synchronization signal enabled on pin 39 -activity LED signal disabled from pin 39 | |
| -pin 39 floating | ||
| Jumper | |
|---|---|
| E1 | Disable Spin Up until command received |
| E2 | Not used |
| E3 | Not used |
| CMOS Drive Parameters | |
|---|---|
| Cylinders | 987 |
| Heads | 16 |
| Precomp | 0 |
| Landing Zone | 987 |
| Mounting Holes |
|---|
| Side: 6-32 UNC-2B .12 Max. Insertion Bottom: 6-32 UNC-2B .25 Max. Insertion |