CP2088
Customer Options
The CP2088 is designed to operate as a master (Drive C) or as a Slave (Drive D). This feature is dependent on two settings; Jumper E1 and the firmware setting of a feature bit. E1 closed and the feature bit is set, the drive will be the Master. E1 open the drive will be the Slave. As a single drive, E1 should be closed.
(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)
| CMOS Drive Parameters |
| Cylinders |
548 |
| Heads |
8 |
| Sectors |
38 |
| Precomp |
0 |
| Landing Zone |
548 |
| Mounting Holes |
| Side: 3mm x 0.5mm THD (4x) 4mm Max. Insertion |
| Bottom: 3mm x 0.5mm THD (4x) 4mm Max. Insertion |