# CONFIG.INI for PC-CONFIG from Version 8.0 # Lines beginning with # are comments only # Possible switches Schalter: 1/0, ON/OFF # Identify installed memory size and speed of graphics adapter? # NB! For this test graphics modi are switched. If CONFIG is running under # WINDOWS in a window, you must disable this test. VideoTest=off # Tries to identify the chip-set on the graphics adapter? VGATest=on # Test access times for the hard disk(s)? AccessTest=on # Always force the data transfer speed test for hard disks, even if an # active cache is detected? ForceHDspeed=on # Test for an active HD cache? HDCacheTest=on # Test for BIOS-Power Saving routines? APMTEST=on # Try to identify main board chip set via hardwaretest. This causes some # computers to crash, and can be disabled. TestBoard=off # Enter boardchipset manually, if detection should fail. # These numbers are vaild: # 0:Autodetect 1:UMC 2:SIS 3:CONTAC 4:ELITE # 5:FOREX 6:OPTI 7:ETEQ 8:SYMPHONY 9:SHASTA Chipsatz=0 # Test the access speed for Extended Memory? (Can be switched off if # this test leads to crashes (because of privilege violations etc.) TestExtMem=on # Do testing of the short interval timer? The test doesn't work on some # 486-66 MHz boards, so it can be disabled here: TimerTest=off # Try to get information about IDE hard disks? Can cause problems # with certain MFM/RLL contollers (eg OMTI 8250). # For registered users only! ATbusInfo=on # Look for sound cards? SearchForSoundCards=on # Minimum required CD-ROM size in MB. If you don't have such a big CD, # you can reduce the value, but the access times are only accurate with # CDs of 600 MB or above. MinCDsize=600 # Define Megabyte for harddisk-capacity: 1000x1000 or 1024x1024 byte Kilobyte=1000 # Look for programs loaded in Hi-Dos? HiDosSearch=on # In case the RAM disk was not detected, its allocated drive letter # (letter only) can be specified here. RamDisk= # A particular drive can be specified here for the DOS read/write # benchmark test. If 0 specified, the test is skipped. If left blank, # the current drive at the time of test will be tested. DosDisk= # Run CONFIG as continuous demo (only available in the commercial # version with a special key). DemoMode=off # How many seconds should the demo run for? DemoZeit=180 # How many seconds should each window be displayed? DemoDelay=8 # Automatic logging during the test? # (only in the commercial version with special key) AutoLog=off # What should be logged/ which windows should be displayed in the demo? # Choose only from menu choices H,W,S,M,B,G:C,Q,T,V,X Protokoll=hwsmtxv # Load and show own comparison list (CONFIG.VGL)? ShowVGL=off # Enable 'Expired' Window Expire=on