Page 1 of 1
IS A 1970 CHALLENGER AND CUDA FRONT CLIP INTERCHANGABLE???
Posted:
23 Jan 2009 6:39by crazy larry
I AM TALKING ABOUT THE FRONT INNER FENDERS AND FRAME RAILS ? I KNOW THE CUDA OVERALL LENGTH IS 6 INCHES SHORTER BUT HOW ABOUT IN THE FRONT END?
Posted:
23 Jan 2009 8:33by dave-r
Front end of the chassis is the same. The only chassis difference is the extra length (two inches) in the floor pan added just behind the front seats.
Bulkhead is the same.
But the inner fenders I am not so sure.
Posted:
23 Jan 2009 18:41by crazy larry
dave-r wrote:Front end of the chassis is the same. The only chassis difference is the extra length (two inches) in the floor pan added just behind the front seats.
Bulkhead is the same.
But the inner fenders I am not so sure.
Posted:
27 Feb 2009 14:57by drewcrane
this is a 70 cuda inner front panels hope this helps from what i can tell they are the same
Posted:
28 Feb 2009 11:15by fbernard
Posted:
28 Feb 2009 12:33by drewcrane
is that how much they cost now? i have a set of new inner fender panels and i paid about 400 bucks ,is that a good price 1400 bucks? wow
Posted:
02 Jul 2009 4:15by 78mako
The inner fenders and the front frame rails are the same for ALL E Body cars and the same inner fenders also fit the B Body cars as well. Actually most parts will interchange from the Challenger and E body Barracuda/Cuda. There are a few exceptions however not very many. Most of the differences are in the exterior body parts due to different body lines and Barracuda/Cuda having a shorter body behind the doors. Other than that they are basically the same car as far as chassis and interior parts go.
