Hood bumper placement • The Dodge Challenger Message Board

by **dave-r** » 01 Jul 2008 20:37

I can't remember or figure out where these two bits go!

Can anyone help?

by **drewcrane** » 01 Jul 2008 20:43

back area of the hood , sorry my flash didnt work,hope you get the idea

by **dave-r** » 01 Jul 2008 21:00

I shall go and check that out. Thanks. :thumbsup:

by **dave-r** » 01 Jul 2008 22:22

Mmmm.

There are two holes in that location on each side. One in front of the other.

The front hole looks on the tight side for the rubber (making me think that will be the one) and the rear hole is slightly on the easy side (making me think that is probably NOT the hole I need).

by **drewcrane** » 01 Jul 2008 23:07

oh yea its the hard one nearest to the cowl,get some of that so called elbow grease, and it will go ,eventually :s023:

by **Jon** » 02 Jul 2008 2:15

I think there should be three, one in the middle also. There may still be remnants on the cowl where they once sat.

Those guys are a bugger, as they can hold the hood up in back and mess with hinge setup and the hood to fender lines.

by **drewcrane** » 02 Jul 2008 2:20

Jon wrote:I think there should be three, one in the middle also. There may still be remnants on the cowl where they once sat.

Those guys are a bugger, as they can hold the hood up in back and mess with hinge setup and the hood to fender lines.

yes they can mess up things especally if there not there over time things will tend to sag and really mess things up! :nod:

by **dave-r** » 02 Jul 2008 7:47

I had worked the one in the middle rear out but didn't remember where these other two went.

I will have to wait until Thursday night to see if I can fit them and what effect they may have on hood alignment. Taking my wife to the movies tonight. :wink: