Page 1 of 1

Scoop? SE Challenger with 1/2 vinyl top?

PostPosted: 27 Jun 2008 15:40
by christer
From an ad:

THIS MOULDING WAS REMOVED FROM A 1970 CHALLENGER SE, BUT SHOULD FIT 70-74. THIS IS A SUPER RARE MOULDING, BECAUSE IT IS A FACTORY OPTIONED VINYL ROOF MOULDING WHERE THE VINYL TOP COVERS ONLY HALF THE ROOF. VERY FEW CHALLENGERS CAME WITH THIS MOULDING.

Is this really true? I thought I had sen it all. Well at least most of it, so I am a bit confused.... :s006:

PostPosted: 28 Jun 2008 2:53
by Alaskan_TA
Do not believe everything you read. This guy is :hmmm:

PostPosted: 28 Jun 2008 3:33
by DAYLEY/CHALLENGER
Barry comes thur again..........................A Challenger with a Landau top............ :hmmm: :hmmm:

PostPosted: 28 Jun 2008 4:10
by Alaskan_TA
Maybe the guys brother (also :hmmm: I am sure) went halvsies on the top so he could use the front half on his T/A;

http://www.challengertaregistry.com/pho ... oto_ta.jpg








:shock:

PostPosted: 28 Jun 2008 6:38
by christer
Alaskan_TA wrote:Do not believe everything you read. This guy is :hmmm:


Ok! Thanks! That is why I added the questionmarks in the topic headline. It was a bit too :hmmm: to be true. Mystery solved. :s024:

PostPosted: 28 Jun 2008 6:41
by christer
Alaskan_TA wrote:Maybe the guys brother (also :hmmm: I am sure) went halvsies on the top so he could use the front half on his T/A;

http://www.challengertaregistry.com/pho ... oto_ta.jpg


So it is a real T/A then? Such a waste! :worry: