70 Challenger emblem

Postby gregvega » 18 Nov 2007 20:12

The fender emblem has the 3 pegs with nuts, but it has the 2 short pegs too. Do these short pegs go in holes or do they tilt the emblem on the fender?
gregvega
Frequent Poster
 
Posts: 79
Joined: 30 Oct 2006 16:28
Location: Alabama
Top

Postby christer » 18 Nov 2007 21:08

It sounds like you have got a grille emblem. Is the part number visible? (or if you can post a pic of the emblem?)
christer
Ghost 48
 
Posts: 2133
Joined: 13 Oct 2006 19:52
Location: Sweden
Top

Postby patrick » 18 Nov 2007 23:53

Yep. :nod:
User avatar
patrick
Frequent Poster
 
Posts: 1323
Joined: 09 Jul 2007 0:56
Location: Washington State, U.S.A.
Top

Postby JackT » 19 Nov 2007 5:19

1970 grille emblems have three long studs and two additional short ones that locate it on the grid of the 1970 grille and make it stand off the plane of the grille. The script Challenger emblems for the fenders have just three studs and the emblem sits flush on the fender's surface.
User avatar
JackT
Frequent Poster
 
Posts: 390
Joined: 18 Oct 2003 2:29
Location: West Hills, California, USA
Top

Postby Eddie » 19 Nov 2007 14:11

I just replaced my grill emblem and of course Pat, Christer,Jack T. are correct! My studs were gnarled and rounded off. Comes from over rubbing your studs :mrgreen:

dodge trucks 417.jpg
User avatar
Eddie
Frequent Poster
 
Posts: 6212
Joined: 16 Oct 2006 21:26
Location: Terre Haute, Ind.
Top

Postby gregvega » 19 Nov 2007 16:17

Ah, that explains that, never thought about the grill. Thanks.
gregvega
Frequent Poster
 
Posts: 79
Joined: 30 Oct 2006 16:28
Location: Alabama
Top