The Dodge Challenger Message Board

Getting ready to remove glass and replace in front doors and quarters.
Anyone know how many of those little snap-in fasteners that go in the window guides on each side?
I will want to replace all the little bumpers/ stops and stuff so if anyone has a list of what and how many I need that would be excellent.

???

Bid is for a new reproduction door window roller kit for 70-72 E-Body Mopar applications. This kit is enough to do both sides of the car.

(From: http://www.ebay.com/itm/Mopar-70-71-72- ... 8a&vxp=mtr )

Mopar 1973 & 1974 E Body Barracuda Cuda Challenger Door Window Roller Kit. 20 Piece Kit As Pictured. This kit is enough to do both doors.

(From: http://www.ebay.com/itm/Mopar-1973-1974 ... e7&vxp=mtr )

Did that answer your question?

That is an epic answer Christer
I think Chuck will be happy with that

So one kit is for the doors? I see two distinctive kits.
Which is which?
Do I need one for the doors and one for the quarters or one of EACH kit to do the doors?

Thanks by the way for the info!

UH..

OK.



I See.


The kit for the 1970 is what I need.

cv70chall wrote:So one kit is for the doors?

Yes, one kit is what you need to repair both the drivers- and the passanger door.

cv70chall wrote:I see two distinctive kits. Which is which?

The upper pic shows the 70-72 version and the pic below shows the 73-74 version.

cv70chall wrote:Do I need one for the doors and one for the quarters or one of EACH kit to do the doors?

If you also need the hardware for the quarter windows, then there is another kit available. (Not shown above.)

Need the quarter window kit too.