Page 1 of 1

Allpar interview with the Product Planner of the Challenger

PostPosted: 12 May 2009 18:31
by jh27n0b
I think that this is a neat interview. Interesting little tidbits that I did not know.
Bob

PostPosted: 12 May 2009 18:32
by jh27n0b

PostPosted: 13 May 2009 4:36
by patrick
Good read, Bob! :thumbsup:

PostPosted: 14 May 2009 14:02
by christer
patrick wrote:Good read, Bob! :thumbsup:


I agree with that! :nod:

Bill Wetherhold wrote:Their doors weighed 87 pounds [before adding hardware and glass]. They had little cranes overhead that had hooks, where you could pick up the door, and maneuver it into the rack. They didn’t work at the time, so when you got to work, you had to pick them up by hand …


It is no news that the doors are heavy. Now I know exactly how heavy they are. :shock:

Burton Bouwkamp wrote:The door trim panels were a problem! Besides being hard to the touch the polypropylene material was unstable and every door panel was a little different dimensionally which made a problem for Car Assembly. The material was flexible so the assembler could force it to fit. Bob Steere (Chief Engineer of Car Assembly) was very critical of this new application for polypropylene.


I am thinking of a guy I once met. He was complaining about the bad fit of his repro interior panels. :lol: :lol: :lol: If he had read this article before then he had probably been less critical.