Postby Eddie » 14 Mar 2007 16:01

Will do Dave. Yeah lots of metal around the mains. More than the 440 Block. www.440source.com 4340 crank, 4340 I-beam rods, 2618 Forged Low silicone pistons,(most ductile), Ductile iron moly rings, race balanced, 1647.00 Total 1197.00 base price but I want the balancing and a few stronger upgrades. Then girdle, Line hone, Ductile Caps, Pro-grams would be better but I am doing this on a budget,(used Race parts that check out are an option), Then after the bottom end is done, I want to buy a used set of Eddies,Bulldogs or INDYS. I know where a set of used INDY 440-1's are for 800.00 complete kit. It's cast iron however and weighs probably 75 pounds more than 906's! Of course this will all be a pipe dream if the block doesnt pass the tests I want! We'll see next month when I drop it off at Best Machine in Michigan. 220.00 for the entire battery of block testing, not too bad. :thumbsup: Here are the dimensions I wish to use Piston Height(from wrist pin centerline)=1.485.=.002 in the hole for 10.7 comp ratio with 88cc chambers. Crank stroke=3.915 Rods=6.535 Piston oil ring does not use spacers or buttons so street use is a viable option although the engine will be noisy,(loose pistons, solid cam, rollmaster chain) ect..470 Total C.I.D. should be able to handle 300H.P. shot of juice.
User avatar
Eddie
Frequent Poster
 
Posts: 6212
Joined: 16 Oct 2006 21:26
Location: Terre Haute, Ind.