For sale on American E-Bay 540" 700 horse street motor

Postby Adrian Worman » 19 Jan 2011 20:40

http://cgi.ebay.com/ebaymotors/ws/eBayI ... escription

Saw this on MMA site, seems mental for the money :o
User avatar
Adrian Worman
Frequent Poster
 
Posts: 2051
Joined: 10 Mar 2007 23:54
Location: milton keynes

Postby christer » 19 Jan 2011 22:02

Remember to install the sub-frame connector kit BEFORE you drop in this beast... :s021:
christer
Ghost 48
 
Posts: 2133
Joined: 13 Oct 2006 19:52
Location: Sweden

Postby MLMFLCN » 19 Jan 2011 22:18

Kind of ominous that the peak torque was 666 :shock:
User avatar
MLMFLCN
Frequent Poster
 
Posts: 238
Joined: 10 Oct 2005 13:24
Location: Ohio

Postby christer » 20 Jan 2011 11:14

MLMFLCN wrote:Kind of ominous that the peak torque was 666 :shock:


It sure is a beast from the top to the bottom. :nod: No question about it. Bad to the bone. :wink:
christer
Ghost 48
 
Posts: 2133
Joined: 13 Oct 2006 19:52
Location: Sweden

Postby dave-r » 20 Jan 2011 12:38

A mate of mine runs an engine very similar to that but making more like 850hp.
You CAN run it on the street but it is a nightmare to keep from stalling, fouling the plugs etc and running to the local cruise and back uses a full fuel cell of fuel.
User avatar
dave-r
Grumpy Old Man
 
Posts: 9842
Joined: 12 Oct 2003 21:45
Location: North of the Tyne, England

Postby christer » 21 Jan 2011 10:45

dave-r wrote:A mate of mine runs an engine very similar to that but making more like 850hp.
You CAN run it on the street but it is a nightmare to keep from stalling, fouling the plugs etc and running to the local cruise and back uses a full fuel cell of fuel.


I have always concidered a Holley 1150 dominator as a race-only-carb. Do you agree with this?
christer
Ghost 48
 
Posts: 2133
Joined: 13 Oct 2006 19:52
Location: Sweden

Postby dave-r » 21 Jan 2011 11:48

Kind of. But I am not sure enough effort is put into making them run correctly.

I got my mates running a little better just with a couple of tweeks at the side of the road without any tools.
The problem with most tuners setting up on Dyno's is they are only interested in tuning for best power at WOT and as long as it will "idle" as well that will do.
No attempt is made to make sure idle and part throttle in low load and high load conditions are taken care of.

I wouldn't mind having a go at tuning one of these engines and carbs. Just to see what can be done and what can't.
User avatar
dave-r
Grumpy Old Man
 
Posts: 9842
Joined: 12 Oct 2003 21:45
Location: North of the Tyne, England

Postby Adrian Worman » 21 Jan 2011 12:19

Its all about quality on a road driven car :wink:
User avatar
Adrian Worman
Frequent Poster
 
Posts: 2051
Joined: 10 Mar 2007 23:54
Location: milton keynes

Postby fbernard » 21 Jan 2011 16:05

christer wrote:I have always concidered a Holley 1150 dominator as a race-only-carb. Do you agree with this?


A friend of mine used to drive to and from Santa Pod with a Dominator, and he had pretty good mileage (17 liters per 100 km). That was a well-known green Challenger...
User avatar
fbernard
Frequent Poster
 
Posts: 733
Joined: 19 Oct 2003 20:41
Location: Paris, France

Postby dave-r » 21 Jan 2011 16:16

Could of sworn he used to change carbs at the track? Saw him doing it one time I'm sure. :?
User avatar
dave-r
Grumpy Old Man
 
Posts: 9842
Joined: 12 Oct 2003 21:45
Location: North of the Tyne, England