Page 1 of 1

2010 challenger spoilers

PostPosted: 25 Jun 2010 2:09
by doitnthdrt
I have 2010 challenger with the normal little spoiler. would like to put the go wing on. does anyone know if bolt holes will line up the same? thanks

PostPosted: 25 Jun 2010 2:17
by drewcrane
Well i have 2 rear wings,

do you want to put an old skool type wing on you new chally?,

if so i can measure the posts and you can check,

just need to make sure you want a wing on the back :s015:

i have seen one and it is not in proportion with the larger size challenger

,it looks to small

, i have asked this question if dodge intends on doing a wing type spoiler factory, but as far as i can tell there not in the plans as of yet,

just so you know , a wing type spoiler will make the car slower ,and act as a drag :s013:

PostPosted: 25 Jun 2010 3:58
by patrick
Yeah. But they look cool. :thumbsup: Good point though, Drew. I didn't think about the old spoiler size apposed, to the new Challenger size. Side by side, it makes one of our cars look like it's parked next to a 74 celica.

PostPosted: 25 Jun 2010 7:34
by dave-r
The new Challenger is wider (as well as taller and longer) so the old type wing is going to look small.