The Dodge Challenger Message Board

I'm looking for someone to post a pic of how the center console glove box door cable attaches inside on both ends for a 70 Dodge Challenger.

Only one end from memory.

dave-r wrote:Only one end from memory.

I'll wager he meant on both ends of the cable.

Ah.

The screw holes should be quite evident. But there is a little spacer the screw goes though so the end of the cable rotates I think? Yes?

Well I thought I was clear but maybe not. I have the cable and the attaching screws but looking in my center console glove box it's not clear where this attaches too. Can someone shed some light on where each end of this cable attaches. I've attached a pic of the short cable. Take a look. Again 70 Dodge Challenger.

Form memory,

Forward edge of the lid and opening. The cable bends towards the hinge when closed. It should be obvious as the screw holes should be there.

I have not seen any close up yet, so I do not know if the reproductions have holes?

Looking towards the back;

From the back looking forward;

That's exactly what I was looking for, thanks Alaskan_TA, UDAMAN!
I appreciate everyones input, thanks.

Ooops! I remembered it was on the front. Glad you put me right again Barry.

Reproductions??

Didn't know they were making these now.

Tony has them;

http://www.tonysparts.com/newproductsE.htm