The Dodge Challenger Message Board

This is likely a long shot, but would anyone be able to get me a photo and/or dimensions on the two bolts that hold the rear quarter window to the regulator?

Yessir, tomorrow.

Are you looking to reproduce the bolts?

Moparman1972 wrote:Yessir, tomorrow.

Are you looking to reproduce the bolts?

I just need to know what I'm looking for. The tiny little depiction of it in the service manual isn't enough to go off of. I have a tray full of bolts, but I don't know if it's in there or if I need to try to track them down, find a suitable replacement and/or improvise, or fabricate if need be.
The quarter window regulators were missing when I got the car, so chances are they're long gone, but if I have the dimensions I might could find something that works.

Ok, here are some pictures. They are of the passenger rear quarter window, and I THINK the driver window regulator. I have forgotten already how they go back together...

I think what you were asking about are the two bolts on the bottom of the window there. They are both shoulder bolts. The one with the gasket goes into the slot in the window guide track, I believe. Or it might have been the other one.... Anyways, one to the window guide track, one to the regulator.

In hindsight, I really should have measured the length of the shoulder on these bolts for you, since you are looking to get similar hardware...my apologies. I will measure them and post the measurements. You should be able to get shoulder bolts easily enough. www.mscdirect.com is a cheap source, if your local hardware store doesn't have them.

....Nevermind about the pictures, USB ports are fried on my computer. I am going to go try the laptop now.