The Dodge Challenger Message Board

Check this out mates, just awesome lookin system, amazingly not over priced either

http://schwartzperformance.com/mopar-e- ... ull-frame/

Sweet! I liked the little smiley after declaring it's not expensive! I would love to have that stuff on my '72' but have already spent as much as a used Viper would cost! I really like the re-inforced front shock towers,, I assume this would be for a compact coil spring front suspension. The chassis can be strengthened by adding some seam welding but only after the front fenders, front end. lower rad support all exposed and cleaned for welding. Then theres the ultimate,, a full roll cage,, where do we go from here! (Vanishing Point)

The most impressive aspect of that system for me is the simplest part and its the single structure of the whole suspension. Unibodies are always lacking rigidity but that addresses all the problems in one go. If you were to buy say an XV or Reilly MS package it would be more than that and you'd still have to fab up the floor pan components.
Its the dogs bollocks that is

With the new framerails clearly inboard of the original ones, I wonder what kind of header you might be able to use with that chassis...