Page 1 of 1

Correct '171' Casting Master Cylinder

PostPosted: 17 Jun 2011 19:13
by Eddie
I had the R/T at school the other day and noticed the generic master had started to leak slightly. I bought a correct '171' Bendix/Chrysler 1970 only master from The Ram Man and installed it yesterday, I of course bench bled the unit and bled the brakes after the install. It works perfectly and doesnt leak. These Masters sell for 1,000 to 1,500 when they become available. I paid less than 1/2 that. Thanks Ram Man(Wayne).

Re: Correct '171' Casting Master Cylinder

PostPosted: 17 Jun 2011 22:23
by Adrian Worman
Just look at the detailing in that engine bay............you keep a lot of us in awe of that car :mrgreen:

Re: Correct '171' Casting Master Cylinder

PostPosted: 17 Jun 2011 22:23
by drewcrane
Man 1 grand ......a person could but a whole car for that :D

Re: Correct '171' Casting Master Cylinder

PostPosted: 20 Jun 2011 14:21
by burdar
Looks good.

Just an FYI...The bracket that bolts to the master and holds the wiring is now being reproduced. You can get it at http://www.amhightechauto.com I think it's pretty cheap too.

Re: Correct '171' Casting Master Cylinder

PostPosted: 20 Jun 2011 14:46
by drewcrane
burdar wrote:Looks good.

Just an FYI...The bracket that bolts to the master and holds the wiring is now being reproduced. You can get it at http://www.amhightechauto.com I think it's pretty cheap too.



Nice site , :D bookmarked

Re: Correct '171' Casting Master Cylinder

PostPosted: 20 Jun 2011 19:35
by Eddie
Thanks Ade, Burdar, I think I'll get that bracket someday Burdar. I have so may incorrect things with my 70, but it drives very nicely since I fixed the 6 Pack and ignition systems! Someday, when I reach Geezerhood, I'll correct all the discrepancies. :lol: