Page 2 of 2

PostPosted: 07 May 2009 1:19
by Jon
johannes wrote:This was an interesting thread,....believe this has been discussed earlier....

I believe I've read somewhere, that the rearaxle sometimes migth be "banana-shaped", and thus effects the handeling of the car.......
...toe in versus toe out on the rear wheels.......

Comments anyone ?
Can a bent rear axle be straigthened in a jigg ???


Sounds plausable. Do you think the rear tires (over the long term) would wear different? Like the inside treads most ?

PostPosted: 07 May 2009 2:02
by Moparman1972
If the axle tube were bent, then the tires would not be set squarely on the ground, and would wear funny.

I have never heard of a bent axle tube where the shaft was fine. I suppose it is possible? I'd think you'd be very aware of the problem though, by self-destructing parts/bearings?

PostPosted: 07 May 2009 7:38
by dave-r
Yes it would be a disaster waiting to happen.

I looked to buy a car once when I was young and luckily my Dad followed be behind when I test drove it. He said the rear wheels were wobbling in and out like mad. :lol:

PostPosted: 07 May 2009 7:45
by dave-r
You don't want anything falling off do you. :wink: