The Dodge Challenger Message Board

Just telling Dave I wanted to bleed my brakes and change my brake pads all round for the Nats, here are some pics.

Ive taken note of what Dave was telling me so I dont expect any problems, Im sure the drums are 11"s

Are there rubber plugs on the wheel cylinder bleeders?

Found one on the rear in the pic, ran out of time to check the rest, I will check later this week.

Wayne. You measure them by taking a drum off and measuring the inside diameter of the drum at the braking surface.

While you have the drums off clean out any dust and dirt (don't breath it) and check for any sign of leaks from the hydraulic cylinder in each drum.

I bet removing those drums is going to be fun.

If he doesn't take off the spindle nut on the front ones it will be.

dave-r wrote:If he doesn't take off the spindle nut on the front ones it will be.

I knew I shouldnt have used the lump hammer!!