Page 1 of 1

8 3/4 shaft bearing

PostPosted: 24 Jun 2004 11:11
by yaro
Hi,
i have a question about 8 3/4 shaft bearing - i have to replace them and I want to install new Mopar Performance set described as a
"Specifically designed by Green Ball Bearing to eliminate the production bearing retainers and axle end play adjusters. Each set contains two axle shaft bearings, two bearing retainer sleeves, two axle shaft seals and two axle flange gaskets."
Do you have any experience with them and do you have any tips...
Jarek
'73 Challenger 440ci

PostPosted: 24 Jun 2004 19:47
by spitfire9137
Hey when you put that 440 in your 73 did you use a wirigin harness from a like 70 big block car or did the small block harness work for you, im gonna do a 318-440 swap on my car when i get aroudn to restoring it.

PostPosted: 25 Jun 2004 14:21
by yaro
This swap was done by previous owner, so I can’t tell you the whole truth. But I think that wiring is from small block with extended connection to distributor.
Jarek

wiring harness

PostPosted: 26 Jun 2004 3:48
by pscartozzi
A little off the original topic but the original harness will work fine. You can see how I did it here;

http://home.nycap.rr.com/pscartozzi/