[Adrian Worman]

These are the ones that allow you to use later unicast discs on an early 72 spindle, sane as the drum brake spindle.
I tried to get a pair of these from Dr.Diff but they haven't machined any for a while and can't promise when they will.
Any where else I can get em from?
I tried to get hold of Scarebird but they haven't replied to any emails.

[Eddie]

I'll try and get ahold of scarebird Ade,,and get you the info mate If I had the dimensions,(Machinists Blueprint),, I could make them for you

[Adrian Worman]

Ah that would be great Ed
I couldn't see em on the website either, even in the odds n ends

[Eddie]

Ah that would be great Ed
I couldn't see em on the website either, even in the odds n ends

I called them and spoke with Scarebird. YES,, they still make that bearing adaptor,,the part number is ,, BNE adaptor,,,cost is 45.00 plus shipping. Hope this helps!

[Adrian Worman]

That's great Ed, I'll use the checkout and see if I can get the order ok for UK
Ta for contacting em Ed, wouldn't answer my emails

[Eddie]

That's great Ed, I'll use the checkout and see if I can get the order ok for UK
Ta for contacting em Ed, wouldn't answer my emails

You're very welcome Ade!