The Dodge Challenger Message Board

These are the ones that allow you to use later unicast discs on an early 72 spindle, sane as the drum brake spindle.
I tried to get a pair of these from Dr.Diff but they haven't machined any for a while and can't promise when they will.
Any where else I can get em from?
I tried to get hold of Scarebird but they haven't replied to any emails.

I'll try and get ahold of scarebird Ade,,and get you the info mate If I had the dimensions,(Machinists Blueprint),, I could make them for you

Ah that would be great Ed
I couldn't see em on the website either, even in the odds n ends

Adrian Worman wrote:Ah that would be great Ed
I couldn't see em on the website either, even in the odds n ends

I called them and spoke with Scarebird. YES,, they still make that bearing adaptor,,the part number is ,, BNE adaptor,,,cost is 45.00 plus shipping. Hope this helps!

That's great Ed, I'll use the checkout and see if I can get the order ok for UK
Ta for contacting em Ed, wouldn't answer my emails

Adrian Worman wrote:That's great Ed, I'll use the checkout and see if I can get the order ok for UK
Ta for contacting em Ed, wouldn't answer my emails

You're very welcome Ade!