Page 1 of 1
Ground and tachometer
Posted:
22 Jul 2013 20:48
by Apewalski70
Hello !
Two questions, when lights is on turn signal are not good and if I push brake pedal the lights are low, bad ground you think ?
My tachometer work but he is connect to the positive terminal of the coil, (on negative he doesnt work) bad coil ?
Thanks you.
Re: Ground and tachometer
Posted:
23 Jul 2013 8:42
by Adrian Worman
Yes, poor ground on the tail light issue, the fault could be just with the grounds from the rear light clusters .
If cleaning and making good the ground doesn't help or only helps a little bit then you have a poor ground somewhere in the entire lighting circuit, so check headlight grounds, sidelights, even the light switch itself.
The tach is fairly easy, if the coil was bad the car won't run so you can eliminate
Check the wiring loom carefully, I'd suggest checking out the wiring schematics at the top of this section.
Re: Ground and tachometer
Posted:
23 Jul 2013 10:40
by Apewalski70
Okay thank you Adrian I will check that
Re: Ground and tachometer
Posted:
23 Jul 2013 11:03
by Adrian Worman
Forgot to ask, factory or aftermarket tach?........ positive side is right anyway
Re: Ground and tachometer
Posted:
23 Jul 2013 11:53
by Apewalski70
Aftermaker from Yearone, I ask to Yearone they said me that :
"If the tachometer works with the gray wire connected to the coil positive terminal it indicates the coil is defective (reversed coil polarity) or the ignition is wired incorrectly (wires attached to the incorrect terminals)."
Positive side send me the good information ?
Re: Ground and tachometer
Posted:
23 Jul 2013 12:24
by Adrian Worman
Oh, sorry, my mistake I typed that in completely wrong
................the grey wire should go to the NEG side of the coil.
Are you certain the power feed is connected to the back of the tach itself?
Re: Ground and tachometer
Posted:
23 Jul 2013 12:32
by Apewalski70
Yes the 2 wires is connected to the back, I changed all the harnesses some years ago so all wires are in good condition, harnesses are from Yearone, I connected all harnesses with the schema so they are in good position.