The Dodge Challenger Message Board

Anybody installed a wiring harness from Painless? Problems or praise? Thanks

The only painless kit I have used was a very small one for the electric radiator fan. It used a thermostat that screws into the water pump and a relay etc. Every wire was labled with it's use along it's full length which I thought was pretty damn good.

My engine bay harness I replaced with a reproduction item from Year One. One of my better ideas. I was glad I did it. That was easy too as every wire was already cut to length and terminated with the correct type end. Everything just fell into place.

You do not say but I guess you are talking about a FULL wiring kit for the whole car? Like the stuff they sell for Hot Rods etc?