The Dodge Challenger Message Board

Hello,
My '70 Challenger ( 8 3/4 posi) is leaking gear oil from the inner rear axle seal into the brake drum on the pass. side.

Anyone done this fix before? What steps are needed? I assume the brake assembly needs to come off and the axle removed? Anyone have the steps down for this?

Thanks very much!

i replaced mine when i changed the bearings i dont recall having any difficulty so it should be easy enough
cheers ian

The axle endplay adjuster is on the passenger side. You will need a dial gauge to adjust end play when you are done. About 8-10 thou endplay I think it is. Check the manual.

You need an axle puller as well of course.

I don't have one so when I have done this in the past I just jam some blocks of wood against the back plate and put the drum on the studs backwards (inside facing out) against the wood. Then I put three wheel nuts on and tighten them so the axle pulls out.

Make sure you remove all the bolts and everything first though. I left a bolt in by mistake once and wondered why the damn thing wouldn't pull out.