The Dodge Challenger Message Board

how much would it cost to convert from an auto to a four speed? are there any major problems with doing this or can i just drop it off at a tranny shop and say "do it".
thanks

wow i am surprized no-one has responded to this,first off you need a pilot bushing installed on the engine block(very important) i have a 4spd you need a "tunnel" for the trans to fit from what i have found(i know there is a hump there for the automatic but someone told me it wasnt enough for a manual to fit) as well as the inside parts - the service manual for 70 gives a good description of the clutch pedal and its components also i think you would need to weld in a spot for the over-center spring to sit on, the outside(engine bay)a z bar, i think the driveshaft would need to be a different length too. oh one last thing the 70s came with was a reverse warning light(not sure about the other yrs) it sits on the pass side of the ash tray, hope this helps?

thank you for taking the time to respond. good info.