[Adrian Worman]

Hi mates, can any body kindly show me a pic or diagram that shows the supporting brackets that attach the exhaust boxes to the rear section of the floorpan. I've always supported the pipe at other points and its never really been right, so I'd like to see how its done proper

[fbernard]

The bracket looks like this :

http://www.hooverautoparts.com/products ... AP-002.php

There's a backing plate inside the car, with the studs, which goes through the floor behind the rear seat back. The bracket is attached to this plate.

TTI makes a simpler copy (no backing plate):
http://www.ttiexhaust.com/ComponentParts/E2530BB-2.jpg


it's the yellow part in this diagram (outer plate shown only) :
http://www.accurateltd.com/Hanger-E-bod ... p_140.html

Accurate also sells a simpler copy with no backing plate, in stainless :
http://www.accurateltd.com/Floor-Pan-Br ... p_219.html

Correctness put aside, I'd rather have a backing plate with welded studs (even if that means making it myself) than self-tapping screws in the floorpan...

[Adrian Worman]

Thanks for that F.B, think I can easy fab something similar to that in a much stronger pattern