The Dodge Challenger Message Board

Anyone running 90 degree boot in your dist. cap plug wires? Seams like it might be crowded. I think I'm going straight in.

I have the 90 degree but then again I have 8mm MSD wires. It would have a long loop at the top of the dizzy with straight connections.

90 degree every time.

Crowded? I don't think so.

Dave also has a large distributor. I have a stock size distributor and 90 degree is crowded. I would go with straight out if you have a stock size distributor.

Moparman1972 wrote:Dave also has a large distributor. I have a stock size distributor and 90 degree is crowded. I would go with straight out if you have a stock size distributor.

But I used to have a stock distributor and if you point the wires out like I have done (and also have #1 in the correct location) it is no problem at all.

On a small block they seem to run all over each other using 90's. Yours looks really clean though Dave.

Sod the firing order! Just put them in so they look neat.

OK,

pop,,,,,,,, pa pop pop,,,,,,, pa pop pop.......