The Dodge Challenger Message Board

Posted: **29 May 2005 1:12**

I tried to post the last few times :?:

I am tring to ID this K member, on our parts car. Also a challenger last digits stamp are a 12..

I'm also looking for frame messurements for challenger 71 Mainly in the front :s002:

Oh yes a little to FAST :s002:

Back to the drawing board...Thats why I was a body tech..

Posted: **29 May 2005 8:53**

"General Chat" is not the place for tech questions thank you.

This is a 1970 frame but same thing. Click on it to enarge.

What do you want to know about the K-frame? There were only two types in Challengers. Slant six engine and V8. The most 440 and 426 cars had a skid plate welded on the bottom so they had a different part number but otherwise they were the same.

Posted: **29 May 2005 13:07**

As for the k-member if you trying to figure out if its a slant 6 or v8 k member this page will help you out...
http://www.engine-swaps.com/frames/fram ... r-ID1.html

Posted: **29 May 2005 18:16**

spitfire9137 wrote:As for the k-member if you trying to figure out if its a slant 6 or v8 k member this page will help you out...
http://www.engine-swaps.com/frames/fram ... r-ID1.html

Or if you prefer to do a in-house search :wink:

: http://challenger.mpoli.fi/forum/viewto ... 9899#19899

Posted: **29 May 2005 19:24**

Soory about adding post in the wrong section :oops:

I tried to apply this post to the tech. did'nt work , But I did get a very good responce Thanks again rpmartworks

Posted: **30 May 2005 7:54**

Thats OK I have moved it now.

The Dodge Challenger Message Board

K member?? have one can't ID

K member?? have one can't ID

thanks